Introduction

  • Thank you for trusting us and acquiring your new headphones. We hope you enjoy them.
  • Before you start enjoying your headphones, we advise you to read this guide to familiarize yourself with them.

Care and maintenance

  • Do not expose your headphones to shocks, dust, moisture, or high temperatures.
  • Do not use corrosive or abrasive cleaning products.
  • Do not disassemble the device. Any manipulation should be carried out exclusively by qualified personnel from Energy Sistem Technology, S.A.
  • Avoid pulling and bending the cables to extend the life of your headphones.
  • It is recommended to avoid excessive bending of the headband and not to force the movable parts.

Warnings and Precautions

Hearing Loss

Listening to music at a high volume can cause permanent damage to hearing. To prevent hearing damage, we recommend:

  • Do not listen to music at a high volume for extended periods.
  • Lower the volume of the playback device before putting on the headphones; gradually increase the volume to a comfortable and moderate level.

    Safety

    For safety reasons and to avoid possible accidents, we recommend:

  • Do not use headphones while driving or engaging in another activity that requires special attention.
  • Keep the product, packaging, and accessories out of the reach of children and pets to prevent accidents and the risk of choking.

General overview

Connect the 3.5mm JACK CONNECTOR (3) of your headphones to the headphone input of your playback device.

To control the playback of your music, you can press the MICROPHONE button (4). One press to pause/resume playback. Two presses to skip to the next song. Three presses to go back to the previous song.

You can adjust the size of your headphones by adjusting the movable elements of the HEADBAND (2).


Imagen1

  1. Driver
  2. Headband
  3. 3.5 mm jack connector
  4. Microphone

Call control*

With the headphones connected to the phone, you can control your calls from the headphone itself.

Answerring an incoming call

To answer a call, press the MICROPHONE button (4) once.

Ending an Ongoing call

To end a call, press and hold the MICROPHONE button (4) for approximately 2 seconds.

Rejecting an Incoming call

To reject a call, press and hold the MICROPHONE button (4) for approximately 2 seconds.

Note: Controls may vary depending on the playback device's configuration.

Warranty

You can check the warranty terms here:
https://www.energysistem.com/terms-warranty

Trademarks

All company, brand, and product names are trademarks or registered trademarks of their respective companies. Specifications are subject to change without notice. © 2018 by Energy Sistem Technology, S.A. All rights reserved.

Declaration of conformity

Declarant's Name: Energy Sistem Technology, S.A. Address: C/ Calpe, 1 - 03509 Finestrat, Alicante (Spain) Tel: +34 966 830 324 VAT ID: A53107488

We declare under our sole responsibility the conformity of the product: Description: Headphones Brand: Energy Sistem Manufacturer: Energy Sistem Technology, S.A. Country of manufacture: China

In accordance with the provisions of Directive EMC 2014/30/EU of the European Parliament and of the Council of February 26, 2014.

Finestrat, October 1, 2023

Imagen1
Miguel Ángel Aragüez García
Innovation and Technology Director