Thank you for trusting us and purchasing your new Vertical Spin. We hope you enjoy it.
Assembly and First Use
Follow these steps to assemble the turntable and start using the product:
-
Place the turntable on a flat, stable, level surface free from vibrations.
-
Remove the clamp securing the tonearm.
-
The drive belt comes pre-installed on the bottom of the turntable platter. Thread the belt through the drive pulley.
-
Insert the turntable platter onto the central spindle. To make it easier to install the belt, you can temporarily remove the three silicone pads. Place the belt over the groove on the drive pulley.
-
Once the belt is properly positioned, push the platter until it clicks into place. Gently rotate the platter by hand a few times to ensure the belt is securely fastened. Replace the three silicone pads on the turntable platter. Note: The silicone pads also act as an anti-slip mat on the platter, so it is important to keep them to ensure they are repositioned correctly.
- Connect the supplied power adapter to the power jack located on the back of the turntable, and then plug it into a wall outlet.
You can also click [here](https://www.youtube.com/watch?v=2btYmw-1pY8 ‘here') to watch a video on how to fit the chainring correctly.
Use Guide
Consult the guide by clicking here.
Frequently Asked Questions (FAQs)
The turntable platter isn't spinning. What could be the cause?
If the turntable platter isn't spinning, it's most likely because the drive belt isn't properly installed.
Make sure the fturntable platter drive belt is correctly mounted on the pulley that transfers motion to the turntable platter.
Safety and maintenance
- Do not apply corrosive or abrasive cleaning agents to the device.
- Do not disassemble the device. Any repair must be carried out exclusively by qualified Energy Sistem Technology, S.A. personnel.
Warranty
You can check the warranty conditions here.